View Full Version : Injector problems
kengodfrey
06-27-2014, 09:57 PM
I recently changed injectors in 1991 ZR1. Sometimes it cranks fine, runs perfect, and sometimes it sputters out black smoke, and smells like raw gas. I am assuming it is the injectors, but wanted other opinion before i pull them out and have them checked.
Thanks
Schrade
06-27-2014, 10:55 PM
Maybe do static pressure test and leakdown time.
Doesn't seem likely tho', that it's a leak problem...................
Kevin
06-27-2014, 11:05 PM
what injectors did you use? What else has been done to the car recently? who did the work? Are you sure everything is connected properly
vettn71
06-28-2014, 10:02 AM
If you didn't flush your fuel rails during replacement it could be a bit of dirt got in an injector. Even if you did flush them it can happen
Goof luck
Jim
XfireZ51
06-28-2014, 10:22 AM
what injectors did you use? What else has been done to the car recently? who did the work? Are you sure everything is connected properly
Ditto.
Paul Workman
06-28-2014, 11:02 AM
Sounds like a leaking injector. As suggested, a static leak test will verify it, and if so, the injector(s) at fault can be isolated.
Install a fuel pressure gauge to the Schrader valve on the front of the passenger side fuel rail.
Turn the ignition switch to RUN, without starting the motor, just long enough for fuel pressure to stabilize.
Monitor the pressure. If all is well, pressure should hold to within a couple pounds for 10-30 minutes (mine held to 30 min). (But, in your case, it sounds like a major leak, and you may even be able to observe fuel jetting from the bad injector if the ignition switch is left in RUN long enough to look down the IH bores at all 16 injectors.)
RICHARD TILL
06-28-2014, 01:03 PM
Read your plugs.
Schrade
06-28-2014, 02:33 PM
If your lines were fouled, your INJ's might need breakdown...
http://forums.corvetteforum.com/images/icons/icon1.gif What can ya' do to an injector with a hammer, a prybar, and a 16mm open end?
This:
http://forums.corvetteforum.com/attachments/c4-tech-performance/47624174d1211902114-gasket-replacement-a-few-pics-00002.jpg
http://forums.corvetteforum.com/attachments/c4-tech-performance/47624175d1211902114-gasket-replacement-a-few-pics-00003.jpg
http://forums.corvetteforum.com/attachments/c4-tech-performance/47624176d1211902114-gasket-replacement-a-few-pics-00004.jpg
http://forums.corvetteforum.com/attachments/c4-tech-performance/47624177d1211902114-gasket-replacement-a-few-pics-00005.jpg
Curious as to what type of injectors did you use?
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.