Secondary Port Control Solenoid Resistance

[lakemeadzmonster]

I have a digital Fuke 93 and out of curiosity I wanted to compare my replacement Solenoid with the old one which is what my Tech 1 seemed to be telling me was my problem.

I compared the Ohms between pins on both and have two very different readings? Does anybody have a new one that they can check or a known good one?? or does anybody have it written down the resistance of a good one?? :dontknow:

My replacement is also used but pulled to upgrade to a LT5.1 and eliminate this vacuum issues. West Yellowstone , West Yellowstone, I can
do it. :-D


:Eagle:

[lakemeadzmonster]

Thanks Mark Haibeck for the resistance reading of 97 Ohms on a new one. Target must have been 100 Ohms. :cheers:

The one I'm taking out would seem it wasn't toast, as it wasn't going to infinity which is what I was expecting, but reading 50.8 Ohms.:icon_scra

West Yellowstone , West Yellowstone. :wave:

:flag2:

[lakemeadzmonster]

:-D Oh, the other used replacement was reading 93.5 Ohms. Yes that is the one going back in now.

Thanks again Marc.

:usa:

[lakemeadzmonster]

Secondaries are working perfectly. :)

Eveything went back together just fine.

So nice to have the Power of the ZR-1 BEAST BACK!!

Thanks everyone. :handshak:

:flag2: