What Is It?

[Dynomite]

I lost my mind...where do these T-40 and two clips go under the hood or on the LT5?

No...This is not the first time I had brain freeze :D

Thanks,
Cliff

http://i287.photobucket.com/albums/ll142/dynomite007/B%20Engine%20LT5/ST-40_zps294de32f.jpghttp://i287.photobucket.com/albums/ll142/dynomite007/B%20Engine%20LT5/SClips_zps4248f1f9.jpg

[scottfab]

The T40s are for the rear hold downs for the roof panel.
The others are from a 60 series John Deer combine
http://talk.newagtalk.com/forums/thread-view.asp?tid=190023&mid=1388269

[MikeGolf]

Doesn't the silver clip hold the tranmission cable to the upper left side of the transmission? The small hole holds the plastic holding tab for the cable.

[DaveK]

The ones on the left are self-sealing stembolts, the ones on the right are phase coil induction mounts... :)

Dave

[MikeGolf]

http://zr1.net/forum/album.php?albumid=176&pictureid=1936

http://www.zfdoc.com/S640Parts.htm

[Pete]

The screws look like from the trg top.
The silver bracket is to hold down the vent tube for the transmission and the harness for reverse switch,1-4 skip plug,and speedo.
The other looks like it holds a harness wire loom that goes over and around the rear end tunnel just over the C-beam and rear end.

Pete

[GOLDCYLON]

The ones on the left are self-sealing stembolts, the ones on the right are phase coil induction mounts... :)

Dave


Quark would be so proud ;)

[Pete]

Just remembered the loom clip could also be for the harness that runs along side the driver side fender well that one of the fender well screws goes thru it.

Pete