Shrek
06-04-2012, 01:24 PM
Well i've had Oren's 93 for a couple of months to fix a few issues that popped up after I sent it home to FL last spring.
He brought it back up for two issues.
1) no heat (seal in thermostat was all but gone)
2) no start when hot
New thermostat and starter and she's good as new.
Since it was here, why not do a "few" enhancements.
Man did that "SMALL" list snowball!!!
1) OBX headers
2) Hurst shifter
3) lowering kit
4) new 18" Mich. Pilot Sports
5) Beam Plates
6) Brake Pads (Carbotechs)
7) Rotors
8) Brembo brake fluid flush
9) Haibeck Chip (had a Rippie)
10) Aggressive street alignment
Oil change and a rear trans seal when I added the beam plates.
Dyno results after header install.....380 RWHP! A 20 HP increase from last spring. Stock motor with a 409 gear and Power Effects!
Last years Dyno #'s
Had her on the dyno this morning to make sure everything was working properly.
1st pull...key off & power effects open...HP-238.49 TQ-308.21
2nd pull...key on & power effects open...HP-360.81 TQ-332.90
3rd pull...key on & power effects closed...HP-346.94 TQ-332.07
http://i446.photobucket.com/albums/qq186/2manyvettes24/Orens%20ZR-1/DSCN0654.jpg
Here she is ready for her first trip to the track this weekend! :cheers:
http://i446.photobucket.com/albums/qq186/2manyvettes24/Orens%20ZR-1/OrensZR-1.jpg
He brought it back up for two issues.
1) no heat (seal in thermostat was all but gone)
2) no start when hot
New thermostat and starter and she's good as new.
Since it was here, why not do a "few" enhancements.
Man did that "SMALL" list snowball!!!
1) OBX headers
2) Hurst shifter
3) lowering kit
4) new 18" Mich. Pilot Sports
5) Beam Plates
6) Brake Pads (Carbotechs)
7) Rotors
8) Brembo brake fluid flush
9) Haibeck Chip (had a Rippie)
10) Aggressive street alignment
Oil change and a rear trans seal when I added the beam plates.
Dyno results after header install.....380 RWHP! A 20 HP increase from last spring. Stock motor with a 409 gear and Power Effects!
Last years Dyno #'s
Had her on the dyno this morning to make sure everything was working properly.
1st pull...key off & power effects open...HP-238.49 TQ-308.21
2nd pull...key on & power effects open...HP-360.81 TQ-332.90
3rd pull...key on & power effects closed...HP-346.94 TQ-332.07
http://i446.photobucket.com/albums/qq186/2manyvettes24/Orens%20ZR-1/DSCN0654.jpg
Here she is ready for her first trip to the track this weekend! :cheers:
http://i446.photobucket.com/albums/qq186/2manyvettes24/Orens%20ZR-1/OrensZR-1.jpg