Torchred96
01-15-2012, 08:48 PM
No, not me, but apparently my secondary injectors had been replaced by 24lb accel injectors the number on the side reads 01D104B. Also, when I first took it down months ago, several of the original primary injectors ohmed between 5 and 9 ohms. Only 3 were around 12.5ohms as I recall. All the accels, were 14.4 to 14.5, though as I said 24lb.
Just installed all the new 21 lb/hr injectors. Thanks to Jerry for getting my o-rings (and gaskets) here so fast for the primaries. They fit in the machined slots of the IH perfectly and as Cliff pointed out, the smaller o-ring lower injector gets removed. It makes sense since if you put primary injectors in their holes, the small o ring doesn't even touch the housing to seal anything. I don't know what would happen if it fell off, if anything.
Anyway, I'm getting close! :dancing
Just installed all the new 21 lb/hr injectors. Thanks to Jerry for getting my o-rings (and gaskets) here so fast for the primaries. They fit in the machined slots of the IH perfectly and as Cliff pointed out, the smaller o-ring lower injector gets removed. It makes sense since if you put primary injectors in their holes, the small o ring doesn't even touch the housing to seal anything. I don't know what would happen if it fell off, if anything.
Anyway, I'm getting close! :dancing