O2 Sensor Extension from Stainless Works was assembled backwards

[USAFPILOT]

The contacts inside the connectors are reversed from what they should be making it impossible to connect the male to female plugs. How do I go about correcting it? I figure the two can be reversed but don't know the "trick" to disassemble. Do any of y'all know how to do it?

[Hammer]

Need a special Weather Pack Release tool. You can get it, or order it, from NAPA or here http://www.whiteproducts.com/tools.shtml

It slips into the end and releases the little tab that holds the pin in.

[USAFPILOT]

thanks hammer, I ordered it from napa...maybe when it gets here tomorrow I can correct SW's mistake. This isn't the first time they have done this either.

[Hammer]

Not a problem at all.