368 Connecting Rods; Oliver Rods

[LGAFF]

I have 6 used but mint condition Oliver rods..... 8 rods retail for $1249 plus shipping and Tax


Will sell the 6 rods for $370 shipped, these are much lighter than stock

Buy two more from manufacturer and have a set for half the cost of new shipped

Oliver Connecting Rods
Billet Connecting Rod 6-3G
5.850 STD LT [LIN]
208H-S7C-017-130501-107
Reciprocating 178.8
Rotating 479.0
Total 657.8

[LGAFF]

http://i134.photobucket.com/albums/q115/lgaff/256.jpg

[LGAFF]

Confirmed with Oliver, need to weight overall rod, front and back and they will sell off the shelf replacements at the off the sheld price. I thinks its about $160 per rod

[XfireZ51]

PETE,

There it is. 10's staring you in the face and Lee is in Chicagoland!!!

[LGAFF]

Rep said these rods are nearly impossible to bend or break, said they even survive pistons coming apart, etc

[LGAFF]

Sale pending

[XfireZ51]

Sale pending


Greek, from the Middle East, or full of tomato sauce?

[LGAFF]

I am checking something if my math is right, a 5.85 rod with s 4.00 liner and JE pistons means a 385

I think thats close to 600hp with cams

[Jagdpanzer]

Lee,
What size is big end bearing and what crank throw are you considering to get 385 CID?

[LGAFF]

Thats what I was going to ask you when I called earlier:)

[LGAFF]

These were rods Paul D bought from Lingenfelter or John Marshall; appears they are 385 rods...takeouts as he went to 415

The ZR-1 featured here is just what the doctor ordered on all counts. Drop-shipped directly to Lingenfelter, the LT5 was immediately stroked out to displace 385 cubic inches, and produced 575 horsepower at the flywheel. Since then, it has been further stroked out to 415 cubic inches, and now produces in the neighborhood of 630 horsepower.


Read more: http://corvettefever.automotive.com/11805/4714-1991-chevrolet-corvette-zr-1/index.html#ixzz1NlWPDz00

[Polo-1]

Hey Lee

I think this might be getting a little off on the info. I'll put my 2 cent in...

The 5.850 rods are a up grade for the 350-441 ci motors. This helps the rod angle in the motors for less piston side load. The factory rods are a very nice "stock" rod, but are 5.740 long. This would increase rod angle. Most would say this is a bad thing ( I think that way too). Some of us went to a 6.00 rod. This longer rod can only be used up to a 4.00 stroke ( 350-402, or big bore 427). The 415,441 with the 4.125 stroke will not use the 6.00 rod( pin is to high up in the rings). Any ways these Oliver rods you have will work VERY nice in any LT5 up to 441ci. The pistons will be ordered for the 5.850, this will locate the pin in the correct spot. For anyone looking to upgrade any ci LT5 These are the SH*@ Olivers will hold Massive power, N2O, Turbo, whatever...

[LGAFF]

Decided to stick 350 on this build

These are back up for sale $370 shipped

[LGAFF]

possible sale..item pending