Where to buy O2 Extension harness

[limey]

Picked up some of the OBX headers and need the extension harness, who's got them pre-made?

[ZR1@gmx.com]

I bought an aftermarket Bosch O2 sensor, it came with an 18 inch leash with a splice connector that worked excellent. did not even have to unplug the old connector which is a bear to get to. You just need it on the passenger side. driver side fits.
http://i1132.photobucket.com/albums/m575/khaulotte/Header%20Install/IMG_2208.jpg
http://i1132.photobucket.com/albums/m575/khaulotte/Header%20Install/IMG_2212.jpg
http://i1132.photobucket.com/albums/m575/khaulotte/Header%20Install/IMG_2213.jpg
http://i1132.photobucket.com/albums/m575/khaulotte/Header%20Install/IMG_2216.jpg

[HAWAIIZR-1]

http://www.zr1products.com/#!products

I bought mine from Randy. If I recall, I bought mine separately and did not need the entire kit.

[XfireZ51]

Kurt,

Tell us what you think of the OBX headers?

[limey]

Kurt,

Tell us what you think of the OBX headers?

These OBX headers are EXCELLENT quality and value for money, i was very impressed with the welding, as well as the materials used, not to mention they came with all clamps and extensions for the RH side header. The only thing they don't have is the 02 extension.

My customer wanted them jet hot coated bright red, so i sent them to Jethot last week, i'll take somes pics when i get them back, not sure red headers are everyones cup of tea, but i'm sure they will look pretty slick when done.

I will not hesitate to sell these in the future, but until my customer actually fits them to his car, i'll hold of endorsing them fully. At this point though, there are people that have installed them and they fit as good as any other headers made. These are made in China, but at this point in time, i often wonder what GM sells themselves that isn't, heck i get AC delco parts all the time and lots of it is stamped MIC.

[ZR1@gmx.com]

My OBX Header installation was easy and a perfect fit. I was a little concerned about how close they were to the steering column so I made a small dent in them to accommodate the column... I probably could have got away without the divot but it would have been close!