Intake Torx Bolts size?

[TFENT]

I tried to search for this question but can't find the true answer..

I ran into the snap-on guy this week and told him I needed and extra long T-size 3/8 ratchet extension to pull the intake on the Z if I needed to again but went blank when I was asking for the correct T-size.

So the question is what is the correct torx size of the bolts for the intake bolts? T-40 or T-45??

[HAWAIIZR-1]

I tried to search for this question but can't find the true answer..

I ran into the snap-on guy this week and told him I needed and extra long T-size 3/8 ratchet extension to pull the intake on the Z if I needed to again but went blank when I was asking for the correct T-size.

So the question is what is the correct torx size of the bolts for the intake bolts? T-40 or T-45??

It should be a T-40 if we are talking about the bolt, plenum to injector housing.

http://jerrysgaskets.com/store2/root/index.php?main_page=product_info&cPath=13&products_id=406

Download this source from one of the greatest contributors to the ZR-1 and you will be all set for most of these questions. I could not have built my motor on my own without it.

:USFlag:

Aloha from Japan,

Craig