Interesting Junk...

[flyin ryan]

Thought you guys might draw some comparisons & find this a little interesting...

http://forums.vwvortex.com/showthread.php?5134125-Got-engineering&p=69170244#post69170244

[Hammer]

Holy smoke Batman.

[RICKYRJ1]

INSANE! Pure exotic porn. Talk about an open check book :worship:

[FU]

Hoot man titanium galore ! Bet some of those turbo's alone used up a 15-20K bill !

[Aurora40]

Wow, seems very F1 inspired, especially that compact clutch setup and the beryllium internals. Beryllium was banned by F1 in '99. It is apparently very toxic to work with.

[GOLDCYLON]

Wow just Wow !!! :wave:

[todesengel]

..and it is all b.s. Did you guys even bother reading his material list? It's a fake, plain and simple.

[flyin ryan]

I did actually question the guy who sent it to me. Forget about cost & whatnot, but why would a person even attempt to try & use say Ti cams? No gain in it. Would be a pain to harden etc, etc. Berrylium rods? Good for valve seats, not so sure about rods!? I got a kick out of it still. Was waiting for someone to question it...

[todesengel]

I did actually question the guy who sent it to me. Forget about cost & whatnot, but why would a person even attempt to try & use say Ti cams? No gain in it. Would be a pain to harden etc, etc. Berrylium rods? Good for valve seats, not so sure about rods!? I got a kick out of it still. Was waiting for someone to question it...

You know the funny thing is I always wanted to have an aluminum 7m block cast.......until I looked into the cost lol.

There are still some very nicely machined pieces in that thread, too bad they had to try to make it into something other than what it is. I did however get a good chuckle from it :dancing