WTB - C-Beam Bolts

[QB93Z]

I want to buy two C-Beam bolts, 1 front (transmission end) and one rear (differential end). I am going to try to make alignment pins to make C-Beam installation easier.

Email or PM if you have some extra C-Beam bolts to sell or trade.

Jim

[Jagdpanzer]

Jim, what do you have on your mind?
I've had good results lining the C-Beam holes up using an 18" rolling head pry bar. http://images.drillspot.com/pimages/279/27925_300.jpg

Phil

[FU]

http://images.drillspot.com/pimages/279/27925_300.jpg


The persuader.

[QB93Z]

Hi Phil,

I had some trouble (a few minutes of prying) getting the last one we did back together. I am thinking about putting a taper on the thread end of the bolts and use them as a close fit alignment tool.

I saw a pry bar like yours at the store but figured that if it fit in the back end hole, it would be too big for the front holes.

Jim

[VetteMed]

if it fit in the back end hole, it would be too big for the front holes.

Jim

Wait, what were we talking about again?:p