Coupe's Dyno Results Part II

[Coupe89]

http://www.ong-inc.com/ZR1/144159b.jpg


Toss the theared over here from CF
Mods were done in 96

From CF:
The person (Tim) running the dyno saw a lean condition and shut her down.
I saw a post the night before that there was a Dyno GTG. I wasn't think, I should have hookup my laptop and started scanning when then the pull took place.

This is the message from JVD (Jim Van Dorn) about my SS (Street Skinner) #2 The day after I bought it.
Block untouched, all heads, injector housings, plenum and air horn ported and polished, custom cam timing, custom eprom. Those made 475 or so at the flywheel, 380-400 at the wheels.

Also JR (John ******) looked at my chip. (Different story) told me that my tune was a can tune also...

[Paul Workman]

For clarification, I suggested that 355 RW hp was "short" of expectations for a fully ported "Snake Skinner". And, I further suggested Coupe post it over here to (shamelessly recruit him to the board) availing him the expertise of those gurus that hang out here instead of "that other place".;)

P.