PDA

View Full Version : il Plate ZZZR1: Huntley

LGAFF
03-23-2010, 09:31 PM
Anyone know this car? Saw a 1990 black, zzzr1 for plates....around hunntley, looked like it has a 2.25 exhaust and only 1 pipe.
Pete
03-26-2010, 03:40 AM
Not sure but it could be that one Z with a single turbo.

Pete
matszr1
11-02-2010, 02:30 AM
Can't tell you whos car it is but I can tell you that it is not the single turbo one. It is dark red metalic and is currently at Marc's garage in Addison building the engine up right to handle the pressure properly. Its getting new pistons and sleeves to drop the compression down. Replacing the valves to heat harded one and fresh off the engineering table, MLS head gaskets specifically designed for the LT5 engine. I almost forgot to mention that we went up to a 368 since we were replacing the pistons and sleeves anyways. You might still see it before snow falls but it will be back on the road again this spring with a little extra spring in it's step. Can't wait. Marc wants to put a McLeod street twin clutch and flywheel in it that can handle drag racing up to 1200hp. It really makes me wonder what this beast is going to do. I am fairly certian that it will create a few of these. :jawdrop:
ALZR1
11-02-2010, 02:46 AM
Can't tell you whos car it is but I can tell you that it is not the single turbo one. It is dark red metalic and is currently at Marc's garage in Addison building the engine up right to handle the pressure properly. Its getting new pistons and sleeves to drop the compression down. Replacing the valves to heat harded one and fresh off the engineering table, MLS head gaskets specifically designed for the LT5 engine. I almost forgot to mention that we went up to a 368 since we were replacing the pistons and sleeves anyways. You might still see it before snow falls but it will be back on the road again this spring with a little extra spring in it's step. Can't wait. Marc wants to put a McLeod street twin clutch and flywheel in it that can handle drag racing up to 1200hp. It really makes me wonder what this beast is going to do. I am fairly certian that it will create a few of these. :jawdrop:


Who's making the MLS gaskets for you?


AL.
matszr1
11-02-2010, 03:23 AM
I believe Cometic.