WTB: Pair of ZR-1 ported heads complete

[Sgreg]

Anyone got a set on the shelf that needs to go. PM me please. :cheers:

[carter200]

There were some on ebay. Don't know anything about them......:dontknow:

[limey]

I have a set, but only for a heavy modded motor. Have big valves as well. Zero miles since overhauled, massive porting work done and taken off of a 415 motor.

These any good?

[XfireZ51]

What does complete mean?

[Sgreg]

There were some on ebay. Don't know anything about them......:dontknow:

Just couldn't get much info. about the ones on the Bay. I was afraid to bid but the price was right.

[Sgreg]

What does complete mean?

Valves, springs, keepers etc.

[Sgreg]

I have a set, but only for a heavy modded motor. Have big valves as well. Zero miles since overhauled, massive porting work done and taken off of a 415 motor.

These any good?

Might be too much for my car. Stock cubes with PP to plenum and inj. housings, headers and tune..Plenum is 36mm. Wouldn't even match up and big valves are not needed.

[A26B]

I probably have a set of stock heads that will fit your needs, after I take them to Greg VanDeventer for the port work. I visit with Greg & he lives nearby. If we do that, I would suggest you send him your injector housings to insure port match. I can do the eBay price of $1500 for the set, complete with valves, springs & retainers, PLUS whatever Greg charges for his port work. Would you want the secondaries in or out?

[Sgreg]

I probably have a set of stock heads that will fit your needs, after I take them to Greg VanDeventer for the port work. I visit with Greg & he lives nearby. If we do that, I would suggest you send him your injector housings to insure port match. I can do the eBay price of $1500 for the set, complete with valves, springs & retainers. Would you want the secondaries in or out?

Jerry, I would want the secondaries in. Corey did my plenum and inj. housings at 36 which is a good match for my stock cube LT-5. That is a very fair price; let me get back with you tomorrow. I am looking at one other situation before I make my final decision.

[A26B]

After reading my post, I need to clarify, $1500 is for the stock heads. Whatever Greg charges to do the head port work would be additional.

[Sgreg]

After reading my post, I need to clarify, $1500 is for the stock heads. Whatever Greg charges to do the head port work would be additional.

Just got expensive. I am interested but weighing a few options.

[scholtmj]

I have a set, but only for a heavy modded motor. Have big valves as well. Zero miles since overhauled, massive porting work done and taken off of a 415 motor.

These any good?

Any pictures?