Looking for a Set of 5.850" Billet Rods for LT5 Stroker Project

[Jagdpanzer]

Gathering up some parts for my stroker project and looking for a set of 5.850" SBC billet rods, standard LT5 journal size, either new or used if in good condition. Prefer Crower or Oliver but will consider others.

[Polo-1]

Oh No...............

Don't do it. 3 years later and I forgot how much$$$ Still dont have my 402.

Wait for a good car for sale, with motor work done.

[Jagdpanzer]

Oh No...............

Don't do it. 3 years later and I forgot how much$$$ Still dont have my 402.

Wait for a good car for sale, with motor work done.

Kevin,
Sorry, I'm to far along to to pu$$y out now.
Already have a spare 4 bolt engine, 4" Bryant crank and JE pistons to start the project off with.
After rods the remaining major item will be liners.
How about a progress report on your 402 project?
Is the shortblock together yet?
How is the block and liner clearance on the Crower rods you used?

[Polo-1]

I used 2.00 Crower's. I'm not 100% sure if the outside dimension is smaller also, compared to the 2.100 rods.

Rod clearance was easy, just a little buff out on the girdle and the bottom of the block (liner).

I'm having Jeff run down to where me block/parts are. I hope to know tommrow. I was told it would be ready 2 weeks ago...........

http://i7.photobucket.com/albums/y292/kpie/IMG00001-20100128-1644.jpg